Frigidaire FFFS5115PW Instruccion De Instalación

10

Grounding type

Grounding type
wa

wall receptacl

ll receptacle

Po

Power cord with

wer cord with

3-prong 

3-prong  gr

grounded plug

ounded plug

  1  Locate the anti-siphon ring shipped with your 

washer. Place it over the end of the drain hose and 

slide it past the fi rst ring of “accordion” ribs.

  2  Form a “U” shape on the end of the drain hose 

with the hose pointed toward the drain. Place the 

formed end in a laundry tub or a standpipe and 

secure the drain hose with the cable tie (provided 

in the enclosure package) to the standpipe, inlet 

hose, laundry tub, etc. so the hose does not pull 

out from the force of the water.

  3  Plug the power cord into a grounded outlet.

  4  Turn on the power at a circuit breaker/fuse box.
  5  Carefully slide the washer to its fi nal position.  

Recheck for level and rock corners for stability. 

Remove and discard door tape.

  6  Read the Use & Care Guide provided with the 

washer. It contains valuable and helpful information 

that will save you time and money.

  7  Run the washer through a complete cycle, checking 

for water leaks and proper operation.

  8  If you have any questions during initial operation, 

please review the “Service Prevention Checklist” in 

your Use & Care Guide before calling for service.

  9  Place these instructions in a location near the 

washer for future reference.

Check to ensure the power is off at a circuit breaker/

fuse box before plugging the power cord into an outlet.

A wiring diagram and technical data sheet are located 

under the washer top panel, on top of the detergent 

dispenser housing.

The standpipe inside diameter must be 1-1/4” (3.2 cm) 

minimum. There must be an air gap around the drain 

hose in the standpipe. A snug hose fi t can cause a 

siphoning action.