Frigidaire FFFS5115PW Instruccion De Instalación

9

Excessive noise and vibration can be prevented by 

properly leveling the washer.
  1  For free standing installation and with the washer 

within 4 feet (1 m) of its fi nal location, place a level 

on top of the washer. 

  2  Use adjustable pliers to adjust the leveling legs so 

the washer is level front-to-rear and side-to-side, 

and stable corner-to-corner.

  3  Press down on alternate corners and sides and feel 

for the slightest movement. Adjust the appropriate 

leg(s) so the washer sits solidly on the fl oor on 

ALL four legs.  Keep the leveling leg extension at a 

minimum for best performance of the washer.

For pedestal installations, see additional installation 

instructions included with the pedestal.

Hoses are not included with washer purchase. See 

“Accessories” section for various inlet hose kits to fi t 

your specifi c installation.

  1  Run some water from the hot and cold faucets 

to fl ush the water lines and remove particles 

that might clog the water valve screens and to 

determine which faucet is hot and which is cold 

supply.

  2  Connect the HOT inlet hose to the HOT inlet 

connection on the washer and the COLD inlet 

hose to the COLD inlet connection on the washer. 

Tighten by hand until snug. Then tighten each 

supply connection another 2/3 turn with pliers. 

  3  Connect the HOT inlet hose to the HOT water 

supply and the COLD inlet hose to the COLD water 

supply. Tighten by hand until snug. Then tighten 

each supply connection another 2/3 turn with 

pliers. Do not bend, kink or pinch water inlet 

  4  Turn on the water and check for leaks.

RUBBER WASHERS

MUST BE PRESENT