Cisco Systems 7326 Manual De Usuario

Press the bezel toward the device until it clicks into place.

Your WAE supports six 1-inch (26 mm) slim, 3.5-inch low-voltage differential 
(LVD) hard disk drives installed on Ultra-Slim hard disk drive trays.

All hard disk drives being used in the device should have the same throughput 
speed rating. Mixing hard disk drives with different speed ratings will cause all 
hard disk drives to operate at the lower throughput speed.

The SCSI ID assigned to each bay is printed on the bezel.

To maintain proper system cooling, do not operate the device for more than 10 
minutes without either a hard disk drive or a filler panel installed in each bay.

To install a hard disk drive in a bay, follow these steps:

Review the information in the 

, and the 

Remove the filler panel (labeled 3 in 

) from one of the empty bays by 

inserting your finger into the depression at the left side of the filler panel and 
pulling it away from the device.

Place the drive handle in the open position and slide the drive into the bay.

Close the drive handle and reload the appliance. You must reload the appliance for 
the software to recognize the hard disk drive.