Panasonic KX-TC2100AL Manual De Usuario
To select the dialling mode TONE
The TALK indicator light must be off before programming.
The TALK indicator light must be off before programming.
Press
{PROGRAM} N {AUTO} N {*} twice (TONE) N
N {PROGRAM}.
• A beep sounds.
• To cancel during programming, press
• To cancel during programming, press
{PROGRAM}.
• If 3 beeps sound during programming, a wrong key was pressed.
Start again from the beginning.
2 Making/Answering Call
{LOUD}
{REDIAL}
{CH}
TALK
Indicator
Indicator
{TALK}
{RINGER}
1
Press
{TALK}.
• The TALK indicator lights.
• If an alarm tone sounds, see section 6-E.
• If an alarm tone sounds, see section 6-E.
2
Dial a phone number.
3
To hang up,
press
{TALK} or place the handset on the base
unit.
• The indicator light goes out.
• For best operating performance, see section 6-C.
• When you make additional dialling after speed dialling
• When you make additional dialling after speed dialling
such as AUTO (3-B), DIRECT (4-B) or REDIAL, please
make sure to do it after finishing the speed dialling.
Otherwise, the unit may not dial properly.
make sure to do it after finishing the speed dialling.
Otherwise, the unit may not dial properly.
If the handset is off the base unit, press
{TALK}.
• You can also answer a call by pressing any dialling
button
{0} to {9}, {*} or {#} (—Any Key Talk).
OR
If on the base unit, just lift up.
2-A Making Calls
2-B Answering Calls
For New Zealand Users Only: Additional Security Feature
In the event that a call cannot be made from the handset following a power interruption, disconnect
the base unit from the line momentarily then reconnect it. Turn the handset off, and replace it on the
base unit. This will re-establish the security system and the handset can be used as before.
In the event that a call cannot be made from the handset following a power interruption, disconnect
the base unit from the line momentarily then reconnect it. Turn the handset off, and replace it on the
base unit. This will re-establish the security system and the handset can be used as before.
To redial the last number dialled
Press
{TALK} N {REDIAL}.
To select the handset receiver volume
Press
Press
{LOUD} while talking.
• Each time you press the button, the volume
level will change to LOW (preset) or HIGH.
If noise interferes with the conversation
Press
Press
{CH} to select a clearer channel or
move closer to the base unit.
Selecting the ringer volume
The TALK indicator light must be off.
The TALK indicator light must be off.
To select HIGH (preset) or LOW,
press
press
{RINGER}.
Each time you press the button, the ringer
volume will change and the selected
volume will ring.
volume will change and the selected
volume will ring.
• To turn the ringer OFF,
press and hold
{RINGER} until a beep
sounds.
• To turn the ringer ON,
press
{RINGER}.