Panasonic KX-TC2100AL Manual De Usuario

5 cm

6 Things You Should Know

N

N

N

When the RECHARGE indicator flashes or the unit beeps 
intermittently, place the handset on the base unit for about 
9 hours to recharge the battery.

After your Panasonic battery is fully charged:

• The battery operating time may be shortened depending on usage 

conditions and ambient temperature.

• As preventative maintenance, clean the handset and the base unit 

charge contacts with a soft, dry cloth once a month. Clean more 
often if the unit is subject to grease, dust or humidity. Otherwise 
the battery may not charge properly.

• If the battery is fully charged, you do not have to place the handset on 

the base unit until the RECHARGE indicator flashes. This will maximise 
the battery life.

• The battery cannot be overcharged.

To replace the battery:
Press the notch on the cover firmly and slide it as indicated by 
the arrow. Replace the old battery with new one (1-C). Close the 
cover and charge for about 9 hours.

While in use (TALK)

Up to about 7 hours

While not in use (Standby)

Up to about 120 hours

Battery replacement:
If you cleaned the charge contacts and fully charged the 
battery, but after a few telephone calls, the RECHARGE 
indicator flashes, the battery needs to be replaced. Replace the 
battery with a new Panasonic P-P301 (KX-A36A) battery. See 
section 1-C, step 3. When replacing the battery, programmed 
information may be erased. Reprogram if necessary.

RECHARGE
Indicator

This unit can be mounted on a wall.

Press the tabs in the direction of the arrows (

1), then remove 

the wall/desk stand (

2).

Connect the AC adaptor. Tuck the telephone line cord inside 
the wall/desk stand, then push it in the direction of the arrows 
(

1 and 2).

• The word “UP WALL” should face upward.

Connect the telephone line cord. Install screws using the wall 
template below. Mount the unit, then slide down.

• Extend the antenna fully.
• Fasten the cords to prevent it from being disconnected.

1

1

2

1

2

To Power 

Outlet

For Australia
To Telephone Plug 
and Socket
OR

For New Zealand
To Single-Line
Telephone Jack

Screws (not included)

Hooks

5 cm

Calls are transmitted between the base unit and the handset 
using wireless radio waves. For maximum distance and noise-
free operation, we recommend the following:

AC Adaptor (230 – 240 V AC, 
50/60 Hz)

Standby:

Approx. 5 W

Maximum: Approx. 7 W

30 MHz – 39 MHz

Approx. 90 mm x 125 mm x 210 mm

Approx. 260 

g

Ni-Cd battery (3.6 V, 300 mAh)

30 MHz – 39 MHz

Dimensions (H x W x D): Approx. 260 mm x 55 mm x 45 mm
Mass (Weight):

Approx. 170 

g

1,000,000

5 °C – 40 °C

Specifications are subject to change without notice.

Away from electrical appliances 
such as a TV, radio or 
personal computer.

In a HIGH and CENTRAL 
location with no obstructions
such as walls.

Extend
fully.