ZyXEL Communications VMG5313-B10A/ VMG5313-B30A Manual De Usuario
Chapter 9 Routing
VMG5313-B10A/-B30A Series User’s Guide
156
The following table describes the labels in this screen.
9.2.1 Add/Edit Static Route
Use this screen to add or edit a static route. Click Add new static route in the Routing screen or
the Edit icon next to the static route you want to edit. The screen shown next appears.
the Edit icon next to the static route you want to edit. The screen shown next appears.
Figure 60
Routing: Add/Edit
The following table describes the labels in this screen.
Table 38
Network Setting > Routing > Static Route
LABEL
DESCRIPTION
Add new static
route
route
Click this to configure a new static route.
#
This is the index number of the entry.
Status
This field displays whether the static route is active or not. A yellow bulb signifies that this
route is active. A gray bulb signifies that this route is not active.
route is active. A gray bulb signifies that this route is not active.
Name
This is the name that describes or identifies this route.
Destination IP
This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
based on network number.
Subnet Mask
This parameter specifies the IP network subnet mask of the final destination.
Gateway
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Interface
This is the WAN interface used for this static route.
Modify
Click the Edit icon to edit the static route on the VMG.
Click the Delete icon to remove a static route from the VMG. A window displays asking you
to confirm that you want to delete the route.
to confirm that you want to delete the route.
Table 39
Routing: Add/Edit (Sheet 1 of 2)
LABEL
DESCRIPTION
Active
This field allows you to activate/deactivate this static route.
Select this to enable the static route. Clear this to disable this static route without having to
delete the entry.
delete the entry.
Route Name
Enter a descriptive name for the static route.
IP Type
Select whether your IP type is IPv4 or IPv6.
Destination IP
Address
Address
Enter the IPv4 or IPv6 network address of the final destination.