Schneider Electric HRB1684301-01 Manual De Usuario
PowerLogic™ PM5500 series user manual
Chapter 17—MID compliance
HRB1684301-01
145
Lock-protected functions
This section lists the meter’s lock-protected functions for MID compliance. After the
meter is locked, these functions are disabled.
meter is locked, these functions are disabled.
These functions can be accessed from the maintenance menu screen. Use the front
panel buttons to navigate to the Maint > Reset menu.
panel buttons to navigate to the Maint > Reset menu.
Setting up the PM5561
You must configure all the lock-protected setup parameters before locking the meter.
When the meter is locked, those setup parameters cannot be edited.
When the meter is locked, those setup parameters cannot be edited.
Basic setup menu
For MID compliance, the Power System must be set to one of the following settings:
•
3PH4W Wye Gnd (three-phase 4-wire wye grounded)
•
3PH3W Dlt Ungnd (three-phase 3-wire delta ungrounded)
Advanced setup menu
You must use ION Setup to edit the device label.
Clock setup menu
You can also use ION Setup to set or sync the meter time.
Lock-protected setup parameters
Setup menu
Setup submenu
Lock-protected setup parameter
Meter
Basic
•
Power System
•
VT Connect
•
VT Primary (V) and VT Secondary (V)
1
•
CT on Terminal
•
CT Primary (A)
•
CT Secondary (A)
•
CT Primary Neu.(A) and CT Sec. Neu.(A)
2
•
Sys Frequency
•
Phase Rotation
1
If using VTs (i.e., if VT Connect is set to 3VT or 2VT)
2
For 3PH4W Wye Gnd systems that measure I4 current (i.e., if CT on Terminal is set to I1 I2 I3 IN)
Advanced
•
Label
Tariff
•
Mode
HMI
User Passwords
•
Energy Resets
Clock
•
Date
Lock-protected functions
Menu
Submenu
Lock-protected function
Resets
Global Resets
•
Meter Initialization (all)
•
Energies
Single Resets
•
Energy
•
Multi-Tariff