Hoshizaki 73168 Manual De Usuario

57

Remove the old gasket by pulling it directly out of the vinyl gasket retainer. Thoroughly 
clean the gasket area with mild soap and water prior to installing the new gasket. The 
new gasket should be installed at the corners first, then working toward the center at 
the top, bottom, and sides. The arrow-shaped portion of the gasket should be firmly 
seated in the retainer groove for proper assembly. This can be checked by lifting the 
edge of the gasket and observing the engagement.

In order to get a proper gasket fit, it is important not to stretch gasket material 
during assembly.

Contact your local Hoshizaki distributor or Hoshizaki Technical Support if door reversing 
or drawer conversion is desired.

7) Remove the rail access hole sealant and grommet.
8) Push the old fan motor wires (with new fan motor wires securely attached) into the rail 

channel. Once the new fan motor wires are in the channel, replace the access hole 
grommet. Remove the left side panel, then pull the fan motor wires through the rail 
channel. 

9) Disconnect and discard the old fan motor wires. Connect the new fan motor wires.

10) Seal the rail access hole with food grade silicone.
11) Place the new rail fan motor and the fan motor shroud in their correct positions and 

secure. Make sure all wires are clear of the fan.

12) Replace the panel and empty storage pans in their correct positions. 
13) Plug in the unit, then move the power switch to the "ON" position and the rail switch to

the "NORMAL" position to start the unit's cooling process.

14) Do not place food products in the rail area until the rail section has cooled down.

Rail Fan Motor

Rail Fan Motor Shroud

Rail Fan Motor Bracket