U-Line CLR2060SSHR Manual De Usuario
92
Design
■
Features
■
Performance
CONNECTING A DRAIN PUMP
If a gravity drain connection is not available, U-Line strongly recommends the use of the U-Line P60 drain
pump. If your CLR2060 is not equipped with a factory installed pump, a P60 drain pump is available
through your Dealer, or direct from U-Line. If a pump other than the U-Line P60 drain pump is to be used,
it must meet the following specifications:
pump. If your CLR2060 is not equipped with a factory installed pump, a P60 drain pump is available
through your Dealer, or direct from U-Line. If a pump other than the U-Line P60 drain pump is to be used,
it must meet the following specifications:
• It must be UL listed and have a UL listed, 120 VAC, 3-wire grounded power cord.
• Overall maximum outside dimensions of 8-3/4" wide x 5-3/4" deep x 7-3/4" high.
• Minimum flow rate of 15 gallons per hour at 10 feet of lift.
• It must have a sealed sump which does not allow water leakage in the case of a power outage, restricted
• Overall maximum outside dimensions of 8-3/4" wide x 5-3/4" deep x 7-3/4" high.
• Minimum flow rate of 15 gallons per hour at 10 feet of lift.
• It must have a sealed sump which does not allow water leakage in the case of a power outage, restricted
drain or pump failure.
• It must have a check valve in the discharge line to prevent waste water return to the pump.
• It must have an overflow protection control which will shut off power to the ice maker in the event of
• It must have an overflow protection control which will shut off power to the ice maker in the event of
a pump failure.
• Operating temperature range of 50°F to 110°F (10°C to 40°C).
If your CLR2060 is not equipped with a P60 drain pump or an equivalent drain pump, severe damage and
costly repair could result in the event of a power outage, restricted drain or pump failure.
costly repair could result in the event of a power outage, restricted drain or pump failure.
CLR2060 MODEL
Plumbing installation must observe all state and local codes. All water and drain connections
MUST BE made by a licensed/qualified plumbing contractor. Failure to follow recommendations
and instructions may result in damage and/or harm.
MUST BE made by a licensed/qualified plumbing contractor. Failure to follow recommendations
and instructions may result in damage and/or harm.
!