U-Line CLR2060SSHR Manual De Usuario
93
Design
■
Features
■
Performance
AUTOMATIC CLEAN CYCLE INSTRUCTIONS
To maintain operational efficiency, clean unit every six months (depending on water conditions more or
less frequent cleaning may be necessary). If the ice maker requires more frequent cleaning, consult a quali-
fied plumber to test the water quality and recommend appropriate treatment. Use only U-Line Ice Machine
Cleaner (part number 41978).
less frequent cleaning may be necessary). If the ice maker requires more frequent cleaning, consult a quali-
fied plumber to test the water quality and recommend appropriate treatment. Use only U-Line Ice Machine
Cleaner (part number 41978).
1. Set the cycle selector switch (located in the center of the grille) to OFF.
Allow the ice to melt off of the evaporator.
2. Remove all ice from the storage bin.
3. Remove inside front cover by gently pulling away from sidewall. See
3. Remove inside front cover by gently pulling away from sidewall. See
Figure A.
4. Remove the overflow tube by lifting it up while using a slight back and
forth motion to loosen it from the drain hole. See Figure B. The water in the
reservoir will flow down the drain.
reservoir will flow down the drain.
5. Replace the overflow tube after all the water has been drained from the
reservoir.
6. Move the cycle selector switch to the CLN position.
7. When water begins to flow over the evaporator, approximately three
7. When water begins to flow over the evaporator, approximately three
minutes, add one packet of U-Line Ice Machine Cleaner to the reservoir.
8. Reinstall inside front cover.
9. When the self cleaning process stops, approximately 45 minutes, it may
9. When the self cleaning process stops, approximately 45 minutes, it may
be desirable to clean the storage bin. See INTERIOR STORAGE BIN
CLEANING.
CLEANING.
10. Move the cycle selector switch to the ICE position to resume ice
production.
Interior Storage Bin Cleaning
1. Disconnect power from the ice maker.
2. Remove any ice from the storage bin.
3. Wipe down the storage bin with a solution of non-abrasive mild soap or detergent and warm water.
2. Remove any ice from the storage bin.
3. Wipe down the storage bin with a solution of non-abrasive mild soap or detergent and warm water.
Rinse with clean water. Sanitize the bin with a solution of one tablespoon of bleach and one gallon of
water. Rinse thoroughly with clean water.
water. Rinse thoroughly with clean water.
4. Check that all drain connections are in place.
5. Reconnect power to the unit.
5. Reconnect power to the unit.
CLR2060 MODEL
Use only U-Line Ice Machine Cleaner (part number 41978). It is a violation of Federal law to
use this solution in a manner inconsistent with its labeling. Use of any other cleaner can ruin
the finish of the evaporator and will void the warranty. Read and understand all labels printed
on the package before use. Ice machine cleaner is used to remove Lime scale and other
mineral deposits. Refer to the following steps for mineral deposit removal.
use this solution in a manner inconsistent with its labeling. Use of any other cleaner can ruin
the finish of the evaporator and will void the warranty. Read and understand all labels printed
on the package before use. Ice machine cleaner is used to remove Lime scale and other
mineral deposits. Refer to the following steps for mineral deposit removal.
!
UL208
FRONT COVER
U•LINE
U
UL209
OVERFLOW
Figure A
Figure B