Bunn RL00006929 Manual De Usuario

Page 12

Beverage overflows decanter.

Weak beverage.

Brewer is making unusual noises.

1. Beverage left in decanter

1. Type of paper filters

2. Coffee

3. Sprayhead

4. Funnel loading

5. Water temperature

1. Solenoid Valve

2. Plumbing lines

3. Water supply

The brew cycle should be started 

only with an empty decanter under 

the funnel.

BUNN® paper filters should be used 

for proper extraction.

A sufficient quantity of fine or drip 

grind coffee should be used for 

proper extraction.

B.O.M. sprayhead #01082.0000 

should be used to properly wet the 

bed of ground coffee in the funnel.

The BUNN® paper filter should be 

centered in the funnel and the bed of 

coffee leveled by gentle shaking.

Place a funnel over an empty de-

canter on the warmer beneath the 

sprayhead.  Place the On/Off brew 

station warmer switch in the upper 

position, press the start switch, 

and check the water temperature 

immediately below the sprayhead 

with an accurate thermometer.  The 

reading should not be less than 195° 

F.  Adjust the control thermostat 

slightly clockwise to increase the 

water temperature.

The nut on top of the solenoid valve 

must be tight or it will vibrate during 

operation.

Plumbing lines should not rest on 

the counter top.

(A) The brewer must be connected 

to a cold water line.

(B) Water pressure to the brewer 

must not be higher than 90 psi.  

Install a regulator if necessary to 

lower the working pressure to ap-

proximately 50 psi.

32430 121699