Thermador CEP Manual De Usuario

Installation Instructions

Models: CEF304, CEF365, CET304, CET365, CEP304, CEP365, CEP456

*NOTE: The blocked letters, such as A, shown below, refer to illus-

trations on Pages 2 & 4. Match these to the related text pages.

Overall Dimensions A ..................................................................... 2
Power Supply B ............................................................................. 2
Cabinet Preparation and Clearances C ......................................... 2, 3
Junction Box Location D ................................................................. 2
Countertop Cutout Dimensions E .................................................... 2
Installing the Cooktop F ................................................................. 4
Secure Cooktop to Countertop G .................................................... 4
Solid Surface Countertop Installs H ................................................. 4
Installation above a Single Oven I, J, K,  and L ............................... 4
Electrical Connection ...................................................................... 5

See Illustration A, Page 2.  These dimensions are
overall.

ELECTRICAL POWER CONNECTION FOR
COOKTOP
Power Supply is dual rated: 240 Volts or 208 Volts, 4

wire, 60 Hz, with the following circuit breaker

requirements: Models CEF304, CET304 or CEP304 at

30 Amps; Models CEF365, CET365 or CEP365 at 40

Amps or Model CEP456 at 50 Amps

Install a junction box (not supplied), below the counter

top within 3 feet of flexible conduit (supplied) located
at the right rear corner of the cooktop rough-in box.

Plan the installation of the unit so that the location of

the junction box is within 3 feet of the right rear of the

cooktop bottom. It must be accessible from the

front of the cabinet. (An exception to this location

would be for a cooktop installation over a single electric

oven In that situation, refer to Pages 4 and 5 and

Figures I, J, K  and L.

PAGE 1