Graco Inc. ti12008a Manual De Usuario
Pressure Relief Procedure
8
310824D
Pressure Relief Procedure
1.
Turn OFF power and turn pressure control to lowest
pressure setting.
pressure setting.
2.
Hold gun against side of grounded metal flushing
pail. Trigger gun to relieve pressure.
pail. Trigger gun to relieve pressure.
3.
Turn prime valve down.
If you suspect the spray tip or hose is clogged or that
pressure has not been fully relieved after following the
steps above, VERY SLOWLY loosen tip guard retaining
nut or hose end coupling to relieve pressure gradually,
then loosen completely. Clear hose or tip obstruction.
pressure has not been fully relieved after following the
steps above, VERY SLOWLY loosen tip guard retaining
nut or hose end coupling to relieve pressure gradually,
then loosen completely. Clear hose or tip obstruction.
4.
Engage trigger safety lock on gun if unit is being
shut down or left unattended.
shut down or left unattended.
WARNING
Follow this Pressure Relief Procedure whenever you
are instructed to relieve pressure, stop spraying, check
or service equipment or install or clean spray tip. Read
Injection Hazard Warning, page 3.
are instructed to relieve pressure, stop spraying, check
or service equipment or install or clean spray tip. Read
Injection Hazard Warning, page 3.
FLUSH
ti5310a
ti5304a