SMC Networks 10/100 Manual De Usuario
C
ONFIGURING
THE
S
WITCH
2-32
CLI – This example shows the connection status for Port 13.
Configuring Interface Connections
You can use the Port Configuration or Trunk Configuration page to
enable/disable an interface, set auto-negotiation and the interface
capabilities to advertise, or manually fix the speed, duplex mode,
and flow control. All switches have to comply with the Cisco
EtherChannel standard.
enable/disable an interface, set auto-negotiation and the interface
capabilities to advertise, or manually fix the speed, duplex mode,
and flow control. All switches have to comply with the Cisco
EtherChannel standard.
Command Attributes
•
Name – Allows you to label an interface. (Range: 1-64
characters)
characters)
•
Admin – Allows you to manually disable an interface. You can
disable an interface due to abnormal behavior (e.g., excessive
collisions), and then reenable it after the problem has been
resolved. You may also disable an interface for security
reasons.
disable an interface due to abnormal behavior (e.g., excessive
collisions), and then reenable it after the problem has been
resolved. You may also disable an interface for security
reasons.
•
Speed/Duplex* – Allows you to manually set the port speed
and duplex mode.
and duplex mode.
Console#show interfaces status ethernet 1/13
Information of Eth 1/13
Basic information:
Port type: 100TX
Mac address: 00-55-FF-FF-DD-EA
Mac address: 00-55-FF-FF-DD-EA
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full,
Broadcast storm: Enabled
Broadcast storm limit: 6 percent
Flow control: Disabled
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full,
Broadcast storm: Enabled
Broadcast storm limit: 6 percent
Flow control: Disabled
Current status:
Link status: Up
Port operation status: Up
Operation speed-duplex: 100full
Flow control type: None
Operation speed-duplex: 100full
Flow control type: None
Console#