GarrettCom Magnum 6K32T Manual De Usuario

Magnum 6K32 & 6K32T Managed Switch                 Installation and User Guide (12/05) 

 

35 

.

.

Step 8.    Once the  6KPM cards have been installed, the chassis top cover should be 

replaced by matching at the two front corners properly and slide in until it 

reaches the rear end and fit properly to match the holes. Make sure the chassis 

cover is aligned properly before securing the enclosure. Place the front panel 

part at the end by sliding in to the front side and secure it with 12 screws as 

being mentioned earlier. 

  To properly remove a 6KPM card from the 6K32T Managed Switch, follow the 

3 steps below.  

Step 1.  Remove chassis cover      See procedures in Section 3.5.1 above.  

On the top of the daughter module there are six 
retaining screws for each 6KPM card. These 
screws are used to secure a 6KPM card in 
position (see Figure 3.5.3a). Remove the three 
standoffs holding the Granddaughter board with 
the chassis. The screen faceplate screws out from 
the inside front of the chassis cover by loosening 
the 4 screws and bracket while holding it down 
firmly.                           Figure 3.5.3a: Top View 
- 6 retaining screws shown by arrows