GarrettCom Magnum 6K32T Manual De Usuario

Magnum 6K32 & 6K32T Managed Switch                 Installation and User Guide (12/05) 

 

36 

.

.

Carefully and gently pull out the daughter board from the latching connectors, using both 

hands,  gripping the board near the latch-up connectors  as shown in Fig. 3.5.3b .  If the 

now empty slot is 

to remain unused, 

be sure to install a 

6KPM-BLNK face 

plate cover.                       

 

Follow the step 8 to complete the process successfully.  
 
 
NOTE:1. If the modular slot has not being used and moved to other unit, the empty 
slot must be covered with Blank cover, to maintain proper air-inflow inside the unit 
and keep off from dust and other unavoidable substance, otherwise can cause a failure 
in the Switch. 
2. If the PM module in the modular slot is not being installed properly or loose in 
connection, the MNS-6K management software will not boot-up properly and a error 
will generate as –{ failed to read register device type (offset 0x1600) on slot “A or B or 
C or D”}, whichever the slot has been used. 
3. Always boot-up the Switch after any new module installation on modular slot to 
confirm the successful installation, before placing the chassis cover. 

 
Use a DB-9 “null modem” cable to connect the Magnum 6K32T Console Port 
(the RS-232 port on the 6K32T Switch) to the your PC, so that your PC 
becomes the 6K32T’s Console Terminal.   
Note: The DB-9 cable does not include with the 6K32T unit 
package. 

 

 
 

 
 

 

 

 

t 

O

OF

PORT