GarrettCom Magnum 3000 Manual De Usuario

Descargar
Página de 59
Magnum 3000 Stackable Hubs                                   Installation and User Guide (07/06)
 
 
11 
www  GarrettCom  com
.
.
The Group # switch settings must not be the same for any two Magnum 3000 
units operating in one managed stack.   Factory default switch settings cannot be relied 
upon, and the user must check and/or change the Group # address switch settings for 
each managed Magnum 3000 unit installed.
  
 
If a network management software package is in use, the Group # addresses set 
for each Magnum 3000 physical unit will be reflected in the NMS displays, statistics and 
controls that correspond to that unit's Group # address.  (While non-sequential Group # 
addresses will not prevent the units in a stack from working properly in the network, such 
numbering tends to create problems for network administration and are therefore 
discouraged accordingly.) 
 
A Magnum 3000 stack may have from 2 to 20 active units (not including an 
optional 3000-AGT unit, which could be the 21st box in a large stack).  The stacked units 
may be any combination of Magnum 3024s, 3012s,3000X and they may be arranged in 
any order, physically and logically, for Group numbering purposes.  Switch settings for 
Group # addresses of zero and from 21 to 31 are not recognized by the NMS software in 
a managed system, and the use of such Group # addresses is discouraged. 
 
Switch 7 of the eight-position DIP switch is no longer used.  In previous 
versions of the product line it allowed the use of a PC-based SNMP AGENT.  Switch 8 
of the eight-position DIP switch is also unused. 
 
The "P1" DB-9 connector on the upper part of the rear panel is used for a serial 
port into the optional embedded SNMP agent board.  If there is no embedded agent board 
in a unit, "P1" is not present.  See Section 5.1 for operational information on the optional 
SNMP embedded agent board. 
 
2.4 
Magnum 3012 Hub  -  12 RJ-45 Ports, One PM bonus port slot 
 
The Magnum 3012 Hub provides 12 shielded RJ-45 ports on the front of the 
unit, and is otherwise like the Model 3024 described above.  Refer to the descriptive 
material in Section 2.3 above. 
Figure 2.4a, Magnum 3012 Hub, Front View 
Magnum 3000
Stackable Hub
GARRETT
Two LEDs (RX & LINK)
for each RJ-45 10BASE-T port.
Twelve  RJ-45 10BASE-T Ports
  LINK
  RX
Steady On LINK LED = Port is Operational
Flashing LINK LED    = Port is Partitioned
Flashing RX LED        = Port Activity