Cisco Systems 12006 Manual De Usuario

This section describes how to use Flash memory cards in the RP and includes 
information on the following topics:

If there are dual RPs, the PCMCIA slots in the primary RP are designated slot 0 
and slot 1. If there is a second RP, the PCMCIA slots in the second RP are 
designated sec-slot 0 and sec-slot 1. PCMCIA slot 0 is the bottom slot and slot 1 
is the top slot. Both Flash memory card slots on each RP can be used at the same 
time. The following generic procedure can be used to install a Flash memory card 
in either slot position.

Facing the RP faceplate, hold the Flash memory card with the connector end of 
the card toward the slot and the label facing up. (See 

.)

Insert the card into the appropriate slot until the card completely seats in the 
connector at the back of the slot and the ejector button pops out toward you.