Schneider Electric 750VA Manual De Usuario
Smart-UPS X-Series Operation
10
Network Management Card Settings
These settings are available only on units that have a Network Management Card (NMC) and are set in
the factory. These settings can only be modified using an external interface, like the NMC web interface.
the factory. These settings can only be modified using an external interface, like the NMC web interface.
• NMC IP Address Mode
• NMC IP Address
• NMC Subnet Mask
• NMC Default Gateway
Load Shed Time
when On Battery
when On Battery
Disabled
0-32767 sec
The amount of time the outlets will function on
battery power before they will turn off.
battery power before they will turn off.
Load Shed On
Runtime
Runtime
Disabled
• Shutdown with
delay
• Shutdown
immediately
• Turn off
immediately
• Turn off with
delay
• Disabled
When the battery runtime falls below the
specified value, the Controllable Outlet Group
will turn off.
specified value, the Controllable Outlet Group
will turn off.
Configure this time using the
L
OAD
S
HED
R
UNTIME
R
EMAINING
setting.
Load Shed On
Runtime
Remaining
Runtime
Remaining
Disabled
0-32767 sec
When the remaining runtime reaches this level,
the Controllable Outlet Group will turn off.
the Controllable Outlet Group will turn off.
Load Shed on
Overload
Overload
Disabled
• Disabled
• Enabled
• Enabled
(Applicable only for Controllable Outlet
Groups, not the UPS outlets.) When enabled,
the Controllable Outlet Group will turn off
immediately in the event of a power outage
and will have to be manually restarted.
Groups, not the UPS outlets.) When enabled,
the Controllable Outlet Group will turn off
immediately in the event of a power outage
and will have to be manually restarted.
Function
Factory Default Options
Description