Manual De UsuarioTabla de contenidosAbout the UPS4Safety4Product Overview4Front panel4Rear panel4Specifications5Operating Conditions5Environmental Specifications5Installation5UPS5Network Management Card5External Battery Pack5Connect Equipment to the UPS61 . Connect equipment to the outlets on the rear panel of the UPS. Do not use extension cords, pl...62 . Connect the UPS to the building utility power. Connect the UPS to a two-pole, three-wire, gro...63 . Press the On/Off button on the front panel of the UPS to apply power to the unit and all conn...64 . To use the UPS as a master on/off switch, turn on all the equipment that is connected to the ...6Basic Connections6Display Interface7Overview7Using the display interface7Standard Menus7• Operating mode7• Controllable Outlet state, On or Off7• Efficiency of the UPS7• Information about the load7• Battery capacity7• Estimated runtime7• Input and output voltage and frequency7• Information about the last transfer to battery power7• Self-test results7• Language7• Local power quality: Good, Fair, Poor7• Choose Standard or Advanced menus7• LCD Display mode, Always On or Power-Saving7• Audible alarms7• Reset to Factory Defaults7• Unit model number8• Serial number8• Battery installation date8• Suggested battery replacement date8• Replacement Battery Cartridge model number8• UPS firmware version8Advanced Menus8• Energy meter8• Number of external battery packs connected to the UPS8• Load current8• Status of the Controllable Outlet Groups8• Battery voltage8• UPS and Controllable Outlet group delays and settings8• High and lower transfer points8• Sensitivity settings8• Date of last battery replacement8• Hardware version8• Software version8• NMC information (if applicable)8UPS Settings9Start-up Settings9• English9• French*9• German*9• Spanish*9• Italian*9• Good9• Fair9• Poor9• If Good is selected, the unit will go on battery power more often to provide the cleanest power...9• If Poor is selected, the UPS will tolerate more fluctuations in power and will go on battery po...9General Settings9• Never10• Start-up only10• Frequency of test10Controllable Outlet Groups10Overview10Model-specific Controllable Outlet Groups11750VA, 120 V and 230 V111000 VA, 120 V and 230 V111500 VA, 120 V and 230 V11Using the Controllable Outlet Groups and UPS outlets121 . Connect critical equipment to the UPS outlets (except for 1500 VA models; then, connect all c...122 . Connect peripheral equipment to the Controllable Outlet Groups.123 . Use the Configuration menus to configure how the Controllable Outlet Groups will react in the...12Customize the Controllable Outlet Groups and the UPS outlets12• Shutdown with Delay12• Shutdown immediately12• Turn off immediately12• Turn off with delay12• Disabled12• Shutdown with delay13• Shutdown immediately13• Turn off immediately13• Turn off with delay13• Disabled13• Disabled13• Enabled13Network Management Card Settings13Emergency Power Off14EPO Overview14Normally open contacts141 . If the EPO switch or relay contacts are normally open, insert the wires from the switch or co...142 . Secure the wires by tightening the screws.14Normally closed contacts141 . If the EPO switch or relay contacts are normally closed, insert the wires from the switch or ...142 . Insert a wire jumper between pins 1 and 2. Secure the wires by tightening the three screws at...14Service171 . Review the problems discussed in Troubleshooting in this manual to eliminate common problems.172 . If the problem persists, contact APC Customer Support through the APC Web site, www.apc.com.17a. Note the model number of the UPS, the serial number located on the rear side of the unit, and ...17b. Call APC Customer Support and a technician will attempt to solve the problem over the phone. I...17c. If the UPS is under warranty, repairs are free.17d. Procedures for servicing or returning products may vary internationally. Refer to the APC Web ...173 . Pack the UPS in its original packaging. If this is not available, refer to www.apc.com for in...17a. Pack the UPS properly to avoid damage in transit. Never use foam beads for packaging. Damage s...17b. Always DISCONNECT THE BATTERY before shipping in compliance with U.S. Department of Transporta...174 . Write the RMA# provided by Customer Support on the outside of the package.175 . Return the unit by insured, pre-paid carrier to the address given to you by Customer Support.17Transport the UPS171 . Shut down and disconnect all equipment connected to the UPS.172 . Shut down and disconnect the UPS from utility power.173 . Disconnect the UPS from all internal and external batteries.174 . Follow the shipping instructions outlined in the Service section of this manual.17APC Worldwide Customer Support17LIMITED WARRANTY18© 2009 APC by Schneider Electric. APC, the APC logo are owned by Schneider Electric Industries S....20Tamaño: 300 KBPáginas: 20Language: EnglishManuales abiertas