Cisco Systems AIRONET 1000 Manual De Usuario
2-11
Cisco Aironet 1000 Series Lightweight Access Point Hardware Installation Guide
OL-9403-04
Chapter 2 Installing the Access Point
Mounting Overview
Step 7
Attach the cables to the access point.
Note
When the access point is powered up and is associated with a controller (Power LED is green,
Alarm LED is off, and the radio LEDs are blinking), the access point is broadcasting its beacon.
Alarm LED is off, and the radio LEDs are blinking), the access point is broadcasting its beacon.
Step 8
Repeat the these steps for each access point on a horizontal surface.
After mounting all horizontal surface access points, return to deploying the access points,
.
Mounting Access Points Using the Ceiling-Mount Clips
When you are mounting the access point under a suspended ceiling, use the ceiling-mount clips to mount
the access point to the suspended ceiling rails.
the access point to the suspended ceiling rails.
Figure 2-8
Attaching the Ceiling-Mount Clips to the Access Point
Follow these steps to attach the ceiling-mount clips to the access point and mount the access point to
suspended ceiling rails:
suspended ceiling rails:
Step 1
Copy the MAC address from the label on the access point onto the corresponding location on the access
point location map. MAC addresses have the format 00xxxxxxxxxx.
point location map. MAC addresses have the format 00xxxxxxxxxx.
Step 2
Attach the ceiling-mount clips to the bottom of the access point using the factory-supplied machine
screws and washers (see
screws and washers (see
).
135665