Cisco Systems AIRONET 1000 Manual De Usuario

Descargar
Página de 83
 
2-13
Cisco Aironet 1000 Series Lightweight Access Point Hardware Installation Guide
OL-9403-04
Chapter 2      Installing the Access Point
Mounting Overview
Mounting the Access Point Using a Projection Wall Mount Bracket
When you are mounting the access point out from a vertical wall (flat sides along the wall or hallway), 
use an optional factory-orderable projection-mount L-bracket (see 
). Follow these steps to 
attach the access point to the projection-mount bracket and mount the access point to a vertical wall:
Step 1
Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom of 
the access point (see 
). Ensure the spring washers have their convex (high center sections) 
pointing toward the screw heads. 
Note
Do not tighten the screw heads flush with the access point surface or the bracket will not fit under 
the screw heads.
Figure 2-10
Attaching the Mounting Screws to the Access Point
Step 2
Copy the MAC address(es) from the label(s) on the access point onto the corresponding location on the 
access point location map. MAC addresses have the format 00xxxxxxxxxx.
Step 3
Find the required mounting location as identified on your access point location map.
Step 4
Use the projection-mount bracket to mark the four screw holes on the wall. Ensure to leave enough space 
around the access point and base to plug the CAT-5 cable, optional external antenna cable(s), optional 
power supply cable, and optional Kensington MicroSaver security cable into the sides of the access 
point.
Step 5
Mount the projection-bracket to the wall using four screws in the marked locations. Use appropriate 
screws and wall anchors (user supplied). Tighten the wall screws.
Step 6
Position the two screws in the base of the access point over the projection-bracket keyhole slots and slide 
the access point in the direction of the key slots (see 
). If you are unable to attach the access 
point to the bracket, remove the access point and loosen the two access point screws.
Note
After attaching the access point to the bracket, tighten the screws until they securely hold the 
access point.
135667
A. Screws and spring washers
B. Completed assembly