3com 980-000077/002 Manual De Usuario
Manual Configuration of a Central Site Unit for Bridging and IP
2-3
Manual Configuration of a Central Site Unit for Bridging and IP
The central site unit becomes the main host/node for bridging.
CAUTION: Do not reset the unit if has already been installed on the
network and configured to bridge or route IPX, and is required to
continue bridging or routing IPX.
network and configured to bridge or route IPX, and is required to
continue bridging or routing IPX.
CAUTION: If the unit has already been configured, and it is
necessary to keep some of the settings, take a note of the current
configuration settings and port type and put it in a safe, accessible
place.
necessary to keep some of the settings, take a note of the current
configuration settings and port type and put it in a safe, accessible
place.
If the central site unit is being configured for the first time, or if it is
an entirely new installation, then reset the unit to the factory default
settings.
an entirely new installation, then reset the unit to the factory default
settings.
1 Press the [Return] key.
2 Enter
PASSWORD
(in upper-case letters) when the Enter Password
screen is displayed.
3 Enter
CO
STD
4
Do
you
wish
to
keep
IP
Addresses
and
ISDN
parameters
.
KEEP
(Y/N)?
is displayed at the command line. Enter
N
5
This
will
ERASE
all
configurations
.
ERASE
(Y/N
) is
displayed. Enter
Y
6
System
will
now
reboot
is displayed.
7 Follow the on-screen instructions.
8 Enter
PASSWORD
when the Enter Password screen is displayed.
9 Enter
SAVE
and then enter
QUIT
10 Power-cycle the unit by removing and then refitting the power lead.
11 Follow the on-screen instructions.
12 Enter
PASSWORD
when the Enter Password screen is displayed.
Following the above sequence will ensure that the unit is reset to the
factory default configuration and that the unit database is empty.
factory default configuration and that the unit database is empty.
Get_con.bk : BRID_IP.FRM Page 3 Friday, October 3, 1997 1:49 PM