3com 980-000077/002 Manual De Usuario

C

HAPTER

 2: B

RIDGING

 

AND

 IP

3 Enter 

 to display the Remote Units screen.

4 If the central site unit name and IP address are not listed, make a 

manual call of 5 minutes duration. 

5 Enter 

 followed by the central site number.

6 While the call is up, press [Ctrl]+[V] at frequent intervals to refresh 

the Remote Units screen. When the central site unit name appears, 
cancel the manual call.

7 Enter 

 followed by the central site number. Follow step 1 in this 

section for testing the IP Autocall and ISDN Number tables.

If the central site unit name is not listed on the Remote Units screen 
after 5 minutes, carefully check the configuration of both the remote 
and central site units.

8 Enter 

 to close the remote management session or press 

[Ctrl]+[D] if that command cannot be used.

A unit at a remote site can be remotely configured as an IP bridge. 
The remote management and configuration capability allows the unit 
to be configured from the central site, without the need for a 
technician to travel to a remote site.

It is good practise to have ensured that the remote unit was restored 
to the factory default settings before being despatched to the 
remote site.

CAUTION: Prior to despatch, it is essential that the unit has the ISDN 
Network Type field configured to match the ISDN network type at 
the remote site.

Power on the unit and follow the sequence of steps for resetting the 
unit to the factory default configuration, as described in 

 on 

.

Get_con.bk : BRID_IP.FRM  Page 8  Friday, October 3, 1997  1:49 PM