3com 980-000077/002 Manual De Usuario
3
R
OUTING
IP
This chapter shows how to configure units to route IP data packets
between two networks, using ISDN.
between two networks, using ISDN.
Configuration steps are given for:
■
Manual configuration of the central site router.
■
Quick Configuration of the remote router.
■
Remote configuration of the remote router from the central site.
Routing IP
If data is required to be shared or transferred between IP networks
with different network numbers or subnets, the IP protocol cannot
be bridged and has to be routed.
with different network numbers or subnets, the IP protocol cannot
be bridged and has to be routed.
Configuration Options
When configuring a unit to route IP packets using a dial-up ISDN link
between a central site and one or more remote sites, it is
recommended that the central site should be configured manually first.
between a central site and one or more remote sites, it is
recommended that the central site should be configured manually first.
The central site unit cannot be automatically configured using the
Quick Configuration facility, because this facility requires a
ready-configured unit to act as a reference point.
Quick Configuration facility, because this facility requires a
ready-configured unit to act as a reference point.
The Quick Configuration facility should only be used at a remote site.
Alternatively, the remote site unit can be configured by utilizing the
remote configuration facility (
remote configuration facility (
REM
) of the central site unit.
Get_con.bk : ROUT_IP.FRM Page 1 Friday, October 3, 1997 1:49 PM