3com 980-000077/002 Manual De Usuario

C

HAPTER

 3: R

OUTING

 IP

The steps below are intended as an outline of the sequence for 
configuring a unit for bridging and IP. They are for guidance only and 
must be used in conjunction with the full description given in the 
following pages.

There are seven basic steps required for manual configuration of a 
unit for routing IP. The sequence for remote configuration of a unit 
necessitates a similar sequence with additional steps. The additional 
steps are given in 

on 

. The Quick Configuration facility has three steps.

The seven basic steps are:

■

Assign a unique name to the unit.

■

Configure the IP address and subnet mask for the unit.

■

Configure the ISDN network type, if required.

■

Set up the ISDN Numbers table to associate a remote unit name 
with an ISDN number.

■

Set up the ISDN Autocall table to associate a unit IP address with 
a remote unit name.

■

Set up the IP Routing table to associate an IP route with a unit 
name.

■

Enable IP routing.

The three Quick Configuration steps are:

■

Assign the unit name, configure the IP address, a valid network 
subnet mask and the ISDN network type (if required).

■

Specify the ISDN number of the central site router. 

■

Make a manual call to the central site router.

Get_con.bk : ROUT_IP.FRM  Page 2  Friday, October 3, 1997  1:49 PM