3com 980-000077/002 Manual De Usuario
Configuring a Remote Unit from the Central Site
4-11
7 Press [Ctrl]+[E] to submit the new setting.
8 Submitting the new settings causes the remote management session
to disconnect immediately. This is normal.
9 Press [Ctrl]+[D] to return to the central site unit management screens.
10 If the Remote Units screen is not displayed, enter
REM
to display it.
The remote unit entry should now contain the remote unit name and
IP address.
IP address.
11 Select the remote unit and enter
REM
12 Enter
PASSWORD
when the Enter Password screen is displayed.
13 Enter
SAVE
to save the new configuration.
Configure the ISDN Numbers Table
Set up the ISDN numbers table to associate the central site unit name
with its ISDN number.
with its ISDN number.
1 Enter
CO
IS
NU
to display the ISDN Numbers screen.
2 Enter
ADD
to add a new entry to the ISDN Numbers table.
3 Type the name assigned to the central site unit in the Name field and
the ISDN number for that unit in the ISDN Number 1 field.
Do not alter the IP Address, IP Mask or IPX Network fields.
Unit names are case-sensitive and must be entered correctly.
Unit names are case-sensitive and must be entered correctly.
4 Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
Enable NRIP/SAP Learning
RIP/SAP learning has to be enabled to allow the IPX Autocall table to
be constructed.
be constructed.
1 Enter
CO
BR
PA
to display the Filter Parameters screen. Toggle the
Learn Novell RIP/SAP field to
ENABLE
using the Spacebar.
2 Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
Build the IPX Autocall Table
The IPX Autocall table will not be constructed if RIP/SAP learning has
not been enabled.
not been enabled.
Get_con.bk : IPX_BRID.FRM Page 11 Friday, October 3, 1997 1:49 PM