3com 980-000077/002 Manual De Usuario

Configuring a Remote Unit from the Central Site

5-13

The frame type must be correct for the network environment in which
the unit is operating. If the frame type is not correct, the unit will not
pass data. Contact the network administrator for more information
about the frame type used.

7 Press [Ctrl]+[E] to submit the new setting.

The remote configuration session is disconnected when the new
settings are submitted. Note that the configuration has not been
permanently saved.

8 Press [Ctrl]+[D] to return to the central site unit management screens.

9 If the Remote Units screen is not displayed, enter

REM

to display it.

The Remote Units screen should now contain the remote unit name
and IP address.

10 Select the remote unit using the Arrow keys and then enter

REM

11 Enter

PASSWORD

when the Enter Password screen is displayed.

12 Enter

SAVE

to save the new configuration.

Configure the ISDN Numbers Table

Set up the ISDN numbers table to associate the central site unit name
with an ISDN number.

1 Enter

to display the ISDN Numbers screen.

2 Enter

ADD

to add a new entry to the numbers table.

3 Type the name of the central site unit in the Name field.

Unit names are case-sensitive and must be entered correctly.

4 Type the ISDN number of the central site unit in the ISDN Number 1

field.

It is very important to remember that Novell IPX routing uses numbered
links. This means that the ISDN line between this unit and the central site
represents an additional Novell network and has to be assigned a valid
Novell network number.

5 Type the IPX network address of the numbered link in the IPX

Network field, not the IPX network address of the central site unit.

Get_con.bk : IPX_ROUT.FRM Page 13 Friday, October 3, 1997 1:49 PM