Cisco Systems and the ASA Services Module Manual De Usuario
30-8
Cisco ASA Series Firewall CLI Configuration Guide
Chapter 30 Configuring the ASA CX Module
Default Settings
Additional Guidelines and Limitations
•
See the
.
•
You cannot change the software type installed on the hardware module; if you purchase an ASA CX
module, you cannot later install other software on it.
module, you cannot later install other software on it.
Default Settings
lists the default settings for the ASA CX module.
Configuring the ASA CX Module
This section describes how to configure the ASA CX module.
•
•
•
•
•
•
•
Task Flow for the ASA CX Module
Configuring the ASA CX module is a process that includes configuration of the ASA CX security policy
on the ASA CX module and then configuration of the ASA to send traffic to the ASA CX module. To
configure the ASA CX module, perform the following steps:
on the ASA CX module and then configuration of the ASA to send traffic to the ASA CX module. To
configure the ASA CX module, perform the following steps:
Step 1
Cable the ASA CX management interfaces and optionally, the console interface. See the
Step 2
(ASA 5512-X through ASA 5555-X; May be required) Install the software module. See the
Table 30-1
Default Network Parameters
Parameters
Default
Management IP address
ASA 5585-X: Management 1/0 192.168.8.8/24
ASA 5512-X through ASA 5555-X: Management 0/0
192.168.1.2/24
192.168.1.2/24
Gateway
ASA 5585-X: 192.168.8.1/24
ASA 5512-X through ASA 5555-X: 192.168.1.1/24
SSH or session Username
admin
Password
Admin123