Cisco Systems and the ASA Services Module Manual De Usuario
3-3
Cisco ASA Series Firewall CLI Configuration Guide
Chapter 3 Information About NAT
NAT Types
NAT Types
•
•
•
•
•
NAT Types Overview
You can implement NAT using the following methods:
•
Static NAT—A consistent mapping between a real and mapped IP address. Allows bidirectional
traffic initiation. See the
traffic initiation. See the
•
Dynamic NAT—A group of real IP addresses are mapped to a (usually smaller) group of mapped IP
addresses, on a first come, first served basis. Only the real host can initiate traffic. See the
addresses, on a first come, first served basis. Only the real host can initiate traffic. See the
•
Dynamic Port Address Translation (PAT)—A group of real IP addresses are mapped to a single IP
address using a unique source port of that IP address. See the
address using a unique source port of that IP address. See the
.
•
Identity NAT—A real address is statically translated to itself, essentially bypassing NAT. You might
want to configure NAT this way when you want to translate a large group of addresses, but then want
to exempt a smaller subset of addresses. See the
want to configure NAT this way when you want to translate a large group of addresses, but then want
to exempt a smaller subset of addresses. See the
Static NAT
This section describes static NAT and includes the following topics:
•
•
•
•
Information About Static NAT
Static NAT creates a fixed translation of a real address to a mapped address. Because the mapped address
is the same for each consecutive connection, static NAT allows bidirectional connection initiation, both
to and from the host (if an access rule exists that allows it). With dynamic NAT and PAT, on the other
hand, each host uses a different address or port for each subsequent translation, so bidirectional initiation
is not supported.
is the same for each consecutive connection, static NAT allows bidirectional connection initiation, both
to and from the host (if an access rule exists that allows it). With dynamic NAT and PAT, on the other
hand, each host uses a different address or port for each subsequent translation, so bidirectional initiation
is not supported.