Cabletron Systems VHSIM-G02 Manual De Usuario

8. Press down firmly on the VHSIM-G02 until the connectors slide all 

the way onto the pins. Ensure that the standoffs on the interface 
module align with the standoff screw holes on the VHSIM-G02.

9. Secure the VHSIM-G02 to the module faceplate using the mounting 

screws saved in step 5.

10. Secure the VHSIM-G02 to the module standoffs using the standoff 

screws shipped with the VHSIM-G02.

11. Reinstall the interface module in the chassis.

12. Reattach the network cabling to the interface module.

To install a VHSIM-G02 into a standalone device (e.g., 2H252-25R) that 
supports VHSIM technology, perform the following steps:

1. Power down the device and remove the power cord.

2. Note the ports that have cables attached to them. Write down the ports 

and label the cables to make it easier to reattach the network properly 
after the installation. Then disconnect the cables from the ports. 

3. Attach the antistatic wrist strap (refer to the instructions outlined on 

the antistatic wrist strap package).

4. Remove the standalone device chassis cover. Refer to your specific 

standalone device documentation for instructions on removing the 
chassis cover.

To install the VHSIM-G02 in a standalone device, the device 
must first be powered down. Ensure that you remove the power 
cord and ONLY the screws required to remove the chassis 
cover.

The VHSIM-G02 and the device are sensitive to static 
discharges. Use an antistatic wrist strap and observe all static 
precautions during this procedure. Failure to do so could result 
in damage to the VHSIM-G02 or device.