Avaya S8500 Manual De Usuario
Chapter 7: Install an S8500 Media Server as an LSP
68
Installing and Configuring the Avaya S8500 Media Server
February 2007
Verifying that the primary controller identifies the
new LSP
new LSP
1. Wait several minutes after you reset the S8500 LSP. On the primary controller, run the SAT
command list survivable-processor to verify that the LSP server registers, and
that translations are updated.
that translations are updated.
2. If the LSP is registered, the Service State? field shows in-service and the Translations
Updated field shows the time and the date of the update.
Readministering media gateways to point to the LSP
Change the controller list for each G700, G350, or G250 Media Gateway that uses the LSP as
an alternate controller. This change enables the media gateway to seek service from the LSP if
the connection to the primary controller fails.
an alternate controller. This change enables the media gateway to seek service from the LSP if
the connection to the primary controller fails.
For how to change the controller list of the media gateway, see one of the following documents:
●
Installation and Upgrades for the Avaya G700 Media Gateway and Avaya S8300 Media
Server, 555-234-100
Server, 555-234-100
●
Installation and Upgrades for the Avaya G250 Media Gateways, 03-300434
●
Installation and Upgrades for the Avaya G350 Media Gateway, 03-300394
list survivable-processor
Page 1 of xx
SURVIVABLE PROCESSORS
Name Type
ID
IP Address Service Translations
State?
Updated
LSPNYC
LSP
04
128.256.173.101
in-service/idle
03:21 02/19/03
LSPCHI
LSP
05
128.256.113.213
out-of-service
04:32 02/20/03