Avaya S8500 사용자 설명서

Chapter 7: Install an S8500 Media Server as an LSP

Installing and Configuring the Avaya S8500 Media Server

February 2007

Verifying that the primary controller identifies the
new LSP

1. Wait several minutes after you reset the S8500 LSP. On the primary controller, run the SAT

command list survivable-processor to verify that the LSP server registers, and
that translations are updated.

2. If the LSP is registered, the Service State? field shows in-service and the Translations

Updated field shows the time and the date of the update.

Readministering media gateways to point to the LSP

Change the controller list for each G700, G350, or G250 Media Gateway that uses the LSP as
an alternate controller. This change enables the media gateway to seek service from the LSP if
the connection to the primary controller fails.

For how to change the controller list of the media gateway, see one of the following documents:

●

Installation and Upgrades for the Avaya G700 Media Gateway and Avaya S8300 Media
Server, 555-234-100

●

Installation and Upgrades for the Avaya G250 Media Gateways, 03-300434

●

Installation and Upgrades for the Avaya G350 Media Gateway, 03-300394

list survivable-processor

Page 1 of xx

SURVIVABLE PROCESSORS

Name Type

IP Address Service Translations

State?

Updated

LSPNYC

LSP

128.256.173.101

in-service/idle

03:21 02/19/03

LSPCHI

LSP

128.256.113.213

out-of-service

04:32 02/20/03