Cabletron Systems EMM-E6 Ethernet Manual De Usuario
CHAPTER 3: INSTALLATION
3-6
EMM-E6 User’s Guide
3.3
SIMM UPGRADES
The EMM-E6 allows memory upgrades for SDRAM, LDRAM, and
FLASH EEPROM. This section explains how to locate and add or replace
a Single In-line Memory Module (SIMM) for any of these memory types.
FLASH EEPROM. This section explains how to locate and add or replace
a Single In-line Memory Module (SIMM) for any of these memory types.
3.3.1
Locating SIMMs
Each memory type has a specific SIMM slot location on the EMM-E6
mother board. When installing SIMM boards, make sure that you place
them in their proper slots. Figure 3-2 illustrates the EMM-E6 SIMM slot
locations and the direction in which to install the SIMMs.
mother board. When installing SIMM boards, make sure that you place
them in their proper slots. Figure 3-2 illustrates the EMM-E6 SIMM slot
locations and the direction in which to install the SIMMs.
For additional information on SIMMs, or how to upgrade the
memory in your Module, contact Cabletron Systems
Technical Support.
memory in your Module, contact Cabletron Systems
Technical Support.
NOTE
The LDRAM SIMM slot is shipped with an expansion SIMM
located in it. If you are performing an upgrade to LDRAM,
ensure that the upgrade SIMM is placed in the proper SIMM
slot after removing the existing LDRAM SIMM. LDRAM
SIMM modules placed in the lower SDRAM slot will not
provide additional main memory. For further information on
the uses and types of memory in the EMM-E6, please refer to
Chapter 1.
located in it. If you are performing an upgrade to LDRAM,
ensure that the upgrade SIMM is placed in the proper SIMM
slot after removing the existing LDRAM SIMM. LDRAM
SIMM modules placed in the lower SDRAM slot will not
provide additional main memory. For further information on
the uses and types of memory in the EMM-E6, please refer to
Chapter 1.
NOTE
CH1Book Page 6 Wednesday, March 20, 1996 7:48 AM