Cabletron Systems EMM-E6 Ethernet Manual De Usuario
CHAPTER 3: INSTALLATION
3-16
EMM-E6 User’s Guide
3.8
INSTALLATION CHECK-OUT
After connecting to the network, verify that packets can pass over the
network segments via the EMM-E6. Again, you can use two workstations
set up as file server and client. Keep the server workstation stationary in
the wiring closet with the EMM-E6, and use the client workstation to
move to each node connected to the EMM-E6. See Figure 3-9.
network segments via the EMM-E6. Again, you can use two workstations
set up as file server and client. Keep the server workstation stationary in
the wiring closet with the EMM-E6, and use the client workstation to
move to each node connected to the EMM-E6. See Figure 3-9.
1. After the EMM-E6 is installed in the MMAC, connect the server
workstation to either a MIM or to the EMM-E6 via an EPIM or BRIM.
2. Going to each node connected to the MMAC, connect the client
workstation and test the segment.
If a failure occurs, refer to Chapter 14, Troubleshooting.
CH1Book Page 16 Wednesday, March 20, 1996 7:48 AM