Cisco Systems PA-MC-8TE1 Manual De Usuario
linecard-group y-cable
To create a line card group for one-to-one line card redundancy, use the linecard-group y-cable command in
redundancy mode. To remove the line card redundancy group, use the no form of this command.
redundancy mode. To remove the line card redundancy group, use the no form of this command.
linecard-group linecard-groupId y-cable
no linecard-group linecard-groupId y-cable
Syntax Description
An unsigned integer in the range 0 to the (maximum
number of chassis line card subslots/2) -1.
number of chassis line card subslots/2) -1.
linecard-groupId
The link protection type for the line card group.
y-cable
Command Default
No default behavior or values .
Command Modes
Redundancy
Command History
Modification
Release
This command was introduced on the Cisco 10000 series router.
12.2(28)SB
Usage Guidelines
The no linecard-group y-cable command removes the line card redundancy group and frees the
linecard-groupIdfor reuse. The no linecard-group y-cable command succeeds only if there are no subslot
members in the line card redundancy group.
linecard-groupIdfor reuse. The no linecard-group y-cable command succeeds only if there are no subslot
members in the line card redundancy group.
Examples
The following example creates line card group number 1 for one-to-one line card redundancy:
Router(config)#
redundancy
Router(config-red)#
linecard-group 1 y-cable
Related Commands
Description
Command
Configures the redundancy role of a line card in the
line card group.
line card group.
member subslot
Enters redundancy mode.
redundancy
Displays information about a redundant line card or
line card group.
line card group.
show redundancy linecard
Cisco IOS Interface and Hardware Component Command Reference
41
l2 vfi manual through loopback PA-MC-8TE1 + port adapter
linecard-group y-cable