Shop-Vac XPO100 Manual De Usuario

SECTION 2—COMPONENT REPLACEMENT

Part No 1150748

9

XPO

2

™

SECTION 2—COMPONENT 

REPLACEMENT

CAUTION

Ensure not to damage ribbon cable when removing or installing front cover.
DO NOT use Methyl Ethyl Ketone (MEK). This will damage the plastic.

Replacing the Gross Particle Filter or Filter Cover

NOTE: For this procedure, refer to 

FIGURE 2.1.
NOTE: The gross particle filter should be 

replaced as needed.
1. Lift filter cover slightly and pull down 

to remove tabs from the grooves.

2. Lift out the filter from the filter cover.
3. Use a vacuum cleaner or wash with a 

mild liquid dish detergent (such as 
Dawn

™

) and water. Rinse thoroughly. 

4. Thoroughly dry the filter and inspect 

for fraying, crumbling, tears and holes. 

5. Replace filter cover and/or filter.
6. Reinstall the filter cover by placing the 

tabs in the slots and engaging the 

magnet.

NOTE: Use only Invacare gross particle filter.

L

FIGURE 2.1   Replacing the Gross Particle 

Filter or Filter Cover

Accessing XPO

2

 WARNING

When accessing the XPO

2

 remember that battery power is still being applied to the 

internal (PCB) printed circuit board. Care MUST be taken to minimize contact with the 

PCB. DO NOT use any kind of tool (screwdriver, pliers, etc.) when working on the 

internal structure, otherwise, injury and/or damage may occur. Battery power remains on 

the PCB as long as the battery connection is made to the PCB. 

NOTE: For this procedure, refer to FIGURE 2.2 and FIGURE 2.3 on page 10.

Cover

Filter

Magnet

Cover

Tabs

Magnet

Grooves

Filter 

Cover