Life Fitness M051-00K32-A086 Prospecto

 1 

M051-00K32-A086

Special service tools required: none 
 
 

Description: Procedures for programming a.) 
EZ consoles (on this page) and b.) TV consoles 
with remote control units (on page 2). 
 

Kit Contents: Programming device and cable 

(see illustration). A 9-volt battery (not 
supplied) is required to reprogram the TV 

console.  
 

Procedure: In both procedures, the TV 
console stays mounted and the power and 

coax cables stay plugged in (see illustration). 
 
To program the TV on EZ console products: 

1.  Remove the EZ console cable from the 

black 8-pin connector on the back of 
the console.  

2.  Plug the C-SAFE cord into that 8-pin 

connector. 

3.  Place the 9-volt battery in the 

programmer. 

4.  Plug the other end of the C-SAFE cord 

into the programmer. 

5.  The programmer will give this 

feedback that the updating procedure 
is taking place: 

a.  The green LED will glow 

steadily. 

b.  The yellow LED will then glow 

steadily. 

c.  The yellow LED will then begin 

flashing. 

d.  The console software has been 

updated when the green LED 
begins flashing slowly. 

6.  Unplug the C-SAFE cord from the 

programmer. 

7.  Unplug the C-SAFE cord from the 

console. 

8.  Reconnect the EZ console cable. 
9.  Verify that the console’s software 

version matches the software version on the programmer. If the console version 
number is still lower, repeat the procedure.  

 

Battery Compartment Cover

9-volt Battery
Connector

C-SAFE Connector

T

to programmer

T

to console

9-volt Battery

 

 
 
 

Coax

Cable

Power

Cable

Black 8-Pin C-SAFE Connector 

(for in-console control)

  do not use

D