SVAT Electronics CLEARVU10 Manual De Usuario

now you can see

The Remote Viewing Software should 
pop up.

1.  If prompted, enter the DVR 

Information (the same 
information that you entered 
when you previously set up a 
connection group) and press OK

2.  Select the group you wish to 

connect to from the drop down 
menu and click 

 to connect 

to your DVR.

3.  For more information on the 

Remote Viewer settings, refer to 
UNDERSTANDING THE REMOTE 
DVR VIEWER SOFTWARE, pg. 
77-78.

If the Remote Viewing Software does NOT pop up, your 
router is not properly forwarding the necessary port. 

This could be due to a number of problems including 
incorrect settings, presence of a firewall, or a DSL 
modem that has its own IP address. If your DSL modem 
has its own internal IP address, it will not properly 
forward the necessary port. You may have to configure 
PPPoE settings to match the settings provided to you by 
your Internet Service Provider (ISP). Consult your ISP for more information.

NOTE: SVAT technical support cannot troubleshoot modems, since changing these settings can potentially render your modem inoperable. 

Check all your network connections and go through the above steps again to make sure a configuration error was not made.  If you still can not 
view the DVR, use the troubleshooting on the next page to help you verify each step as you complete it.