Samsung CLX-6240FX Manual De Usuario

94 _Installing accessories

5. Holding the memory module by the edges, align the memory module on 

the slot at about a 30-degree tilt. Make sure that the notches of the 

module and the grooves on the slot fit each other.

6. Press the memory module into the slot with care until you hear a 'click'. 

7. Replace the control board cover and fasten the cover with the screws.

8. Replace the rear cover and fasten the cover with the screw.
9. Reconnect the power cord and printer cable, and turn the machine on.

After installing the memory module, you need to select it in the printer 

properties of the PostScript printer driver in order to use it.

1. Make sure that the PostScript printer driver is installed on your 

computer. For details about installing the PS printer driver, see Software 

secion.

2. Click the Windows Start menu.
3. For Windows 2000, select Settings and then Printers.

For Windows XP/2003, select Printers and Faxes.

For Windows Vista, select Control Panel > Hardware and Sound > 

Printers.

4. Select the Samsung CLX-6200 Series PS or Samsung CLX-6240 

Series PS printer.

5. Click the right mouse button on the printer icon and select Properties.
6. For Windows 2000/XP/2003/Vista, select Device Settings.
7. Select the amount of memory you installed from Printer Memory in the 

Installable Options section.

8. Click OK.

The CLX-6200ND, CLX-6210FX and CLX-6240FX is equipped with a 

network interface which allows you to use your machine on a network. You 

can also purchase a wireless network interface card to enable the use of the 

printer in wireless network environments

For order information, see page 91

Review the precautions on page 93 and then follow this procedure to install 

the wireless network interface card in your machine.

1. Turn the machine off and unplug all cables from the machine.
2. Release the screws and remove the rear cover. 

3. Release the screws, then lift up the cover slightly and pull the cover to 

the right. 

The notches and grooves illustrated above may not match those 

on an actual memory module and its slot.

Do not press the memory module strongly or the module may be 

damaged. If the module does not seem to fit into the slot properly, 

carefully try the previous procedure again.

To release the memory module, pull the two tabs on the sides of 

the slot outwards, then the module springs out.