Patton electronic 07MSMARTMEDIA-SCG Manuel D’Utilisation

Configuring an M2PA System

Smart Media Software Configuration Guide 

Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence 
transport of messages. To edit your system's SCTP configuration:

1. Select SCTP from the navigation panel:

Figure 171. Signaling > SCTP

2. Configure the new SCTP service:

– Make sure the box labeled Enabled is checked

– Enter  a  name for the SCTP service

– Select an appropriate service type: RAW_IP or UDP

– Click Create

Figure 172. Creating a New MTP2 Link

3. Verify that the "Sctp Cfg was successfully created" message displays:

Figure 173. Successful SCTP Configuration Message

Table 32. Configuration Parameters for New SCTP Configurations

Used by the Web Portal to indicate a specific object or string in the system

Defines the purpose of an SCTP configuration. Possible values:
RAW IP:

Enables the direct transmission and reception of network packets by 
applications, bypassing all encapsulation in the networking software of 
the operating system.

UDP:

Provides a direct way to send and receive datagrams over IP networks.