Patton electronic 07MSMARTMEDIA-SCG Manuale Utente
Configuring an M2PA System
124
Smart Media Software Configuration Guide
5 • Configuring SIGTRAN Applications
Creating the SCTP Configuration
Stream Control Transmission Protocol (SCTP), a Transport Layer protocol, ensures reliable, in-sequence
transport of messages. To edit your system's SCTP configuration:
transport of messages. To edit your system's SCTP configuration:
1. Select SCTP from the navigation panel:
Figure 171. Signaling > SCTP
2. Configure the new SCTP service:
– Make sure the box labeled Enabled is checked
– Enter a name for the SCTP service
– Select an appropriate service type: RAW_IP or UDP
– Click Create
Figure 172. Creating a New MTP2 Link
3. Verify that the "Sctp Cfg was successfully created" message displays:
Figure 173. Successful SCTP Configuration Message
Understanding Parameters for SCTP Configurations
Table 32. Configuration Parameters for New SCTP Configurations
Parameter
Description
Name
Used by the Web Portal to indicate a specific object or string in the system
Service Type
Defines the purpose of an SCTP configuration. Possible values:
RAW IP:
RAW IP:
Enables the direct transmission and reception of network packets by
applications, bypassing all encapsulation in the networking software of
the operating system.
applications, bypassing all encapsulation in the networking software of
the operating system.
UDP:
Provides a direct way to send and receive datagrams over IP networks.