Universal Remote Control URC-100 Manuel D’Utilisation

Should you wish to make a clean start, you can reset the 
Unifier to its factory default settings by pressing and 
holding both the POWER OFF button and the STOP 
button for ten seconds. Continue to hold both buttons as 
the display flashes ERASE nine times, then CLEAR. 

The Unifier displays a self testing routine for a few 
seconds, then returns to normal operating mode. 

If you wish to recall a previously programmed code 
number so that you can write it down, follow these steps:

Press and hold both the DEVICE button you want to 
identify and the MUTE button. Keep holding them 
down until the display says SET.

Press the INFO button.The Device Name will 
appear (blink twice) followed by the three digit 
number.