Invacare 9805 Manuel D’Utilisation

SECTION 4—ASSEMBLY

SECTION 4—ASSEMBLY

Assembly of the Patient Lift

WARNING

Use only Invacare parts in the assembly of this lift. The base legs, the mast, boom,

pump assembly and the swivel bar are manufactured to specifications that assure

correct alignment of all parts for safe functional operation.

CAUTION

DO NOT run the lift until it is fully assembled.
Follow the assembly instrudctions in the Owner’s Manual for proper assembly of

this lift. Failure to do so could result in damage to the push handle of the lift, render-

ing it inoperative.

NOTE: For this procedure, refer to FIGURE 4.1 and FIGURE 4.2.

Base, Mast and Boom Assembly

1. Unpack the components from the

shipping cartons.

2. Remove the locking screw from the

bottom of the base.

NOTE: The bottom of the mast assembly will
have a notch.
3. Match the notch at the bottom of the

mast assembly with the tabs inside the
socket of the base assembly.

4. Insert the mast assembly into the socket

and onto the tabs.

5. Turn the mast assembly to make sure

that the notch is locked on the tabs of
the socket.

NOTE: If the mast does not turn, the mast is
centered and locked in place.
6. Insert the locking screw into the bottom

of the base and securely tighten.

WARNING

The mast may be removed from the

base for storage or transporting. Each

time the mast is removed and returned

to the socket of the base, the mast

MUST be locked into the socket of the

base assembly.

FIGURE 4.1 Assembly of the Patient Lift -

Locking Screw

Bolt and Locknut

Bottom of mast notch

Top Inside of the

Socket of the

Base Assembly