Panasonic AJ-HD1400P Manuel D’Utilisation

52

*1 Displayed menus may vary depending on the settings in

menu No. 25 SYSTEM FREQ. For details, refer to
“Menus which are displayed” (page 32).

“_____” indicates the factory setting.

For selecting the channel for the signal output to the 
analog audio output terminal CH1/CH2.
0000

For selecting the audio output level during DV format 
playback.
0000

The audio output level is not attenuated.

The audio output level is attenuated.

For selecting whether to mute the sound at the joins 
in the recording during DV or DVCAM format 
playback.
0000

The sound is not muted.

The sound is muted.

For setting whether the tape is to be played back 
without passing the signals through the rate converter 
(without activating the digital filter) in the digital audio 
output unit.
0000

The tape is played back without passing the signals 
through the rate converter.

The signals are passed through the rate converter, 
and the tape is played back.

<Note>
ON/OFF control is exercised for channels 1 through 8 
at the same time. Separate settings cannot be 
performed on a channel by channel basis.

For setting whether to output the analog CUE signal 
to CH1/2 for the audio audio output.
0000

The analog CUE signal is not output.
The PCM audio signal is output when the speed 
range is less than 

j1.0k to +1.0k; while the no 

audio signal is output at any other speed.

The analog CUE signal is output.
The PCM audio signal is output when the speed 
range is less than 

j1.0k to +1.0k; while the 

analog CUE signal is output at any other speed.

For setting the analog audio input impedance.
0000

600

h

High impedance

<Note>
Regardless of this setting, the impedance is set to 
3k

h

. when “–60 dB” is selected as the menu item 

No.701 to 702 settings.

Set the channels to multiplex SD-SDI output.
0000

<Note>
When tape other than DVCPRO HD (LP) is played, 
CH1 to CH4 is always multiplexed.

For selecting channels that are adjusted with the 
audio volume control on the front panel and displayed 
on the audio level meter.
0000

Select CH1–CH4.

Select CH5–CH8.

Select enabled/disabled for MONITOR SELECT 
button operation on the front panel.
0000

Operation is enabled.

Operation is disabled.

Operation is disabled in the FULL display mode 
while the operation is enabled only in the FINE 
display mode.