VTech LS6425 Manuel D’Utilisation

4

Once you have installed the battery, the screen indicates the battery status (see 

the table below). If necessary, place the handset in the telephone base or charger 

to charge the battery. For best performance, keep the handset in the telephone 

base or charger when not in use. The battery is fully charged after 10 hours of 

continuous charging. See the table on page 58 for battery operating times.
If the screen is blank or displays 

Place in charger, you need to charge the 

handset without interruption for at least 30 minutes to give the handset enough 

charge to use the telephone for a short time. When the battery is low, the 

handset displays

 Low battery along with a flashing

   

icon. If you are on a call in 

low battery mode, the handset plays short beeps to alert you.
The following table summarizes the battery charge indicators and actions to take.

Battery indicators

Battery status

Action

The screen is blank, or 

displays 

Place in charger 

and   flashes.

Battery has no or 

very little charge. The 

handset cannot be used.

Charge without interruption 

(about 30 minutes).

The screen displays  

Low battery and   flashes.

Battery has enough 

charge to be used for a 

short time.

Charge without interruption 

(about 30 minutes).

The screen displays 

HANDSET X.

Battery is charged.

To keep the battery charged, 

place it in the telephone base 

or charger when not in use.

If you place the handset in the telephone base or charger without installing a 

battery, the screen displays

 No battery.

After you install your telephone or power returns following a power outage, the 

handset will prompt you to set the date and time (see page 13). To skip setting 

the date and time, press 

/CANCEL.

SET DATE 
MM/DD/YY