Cisco Systems 78-10588-03 Manuel D’Utilisation
Chapter 3
Installing the Chassis
Installing the System
3-4
Cisco Metro 1500 Series Hardware Installation Guide
78-10588-03
Caution
Because of rack mounting, the plugs of the power cables on the rear
side of the unit might not be accessible. Please provide a power
circuit breaker to allow front power access. If you do not use a power
circuit breaker, ensure quick access to the plug-socket combinations
on the rear side of the unit at all times. In this case they serve as the
main means of disconnecting.
side of the unit might not be accessible. Please provide a power
circuit breaker to allow front power access. If you do not use a power
circuit breaker, ensure quick access to the plug-socket combinations
on the rear side of the unit at all times. In this case they serve as the
main means of disconnecting.
Installing the System
Warning
Only trained and qualified personnel should be allowed to install,
replace, or service this equipment.
replace, or service this equipment.
To install, connect, and test the system, follow these steps:
Step 1
Unpack and inspect each unit. Verify completeness against the packing list.
Step 2
Step 3
Mount each unit in a cabinet or a rack.
Step 4
Power up each unit.
Step 5
Run online tests as described in the “Running Online Tests” section on page 3-25.
Step 6
Connect the fiber-optic link between sites using the remote channel.
Step 7
Connect applications using the local channels.
Step 8
Test the system online to verify operation.
Note
If a network element management interface (NEMI) is not installed,
you have completed this portion of the installation tasks. If a NEMI
is installed, refer to the Cisco Metro 1500 Series Software
Configuration Guide and continue with Step 9.
you have completed this portion of the installation tasks. If a NEMI
is installed, refer to the Cisco Metro 1500 Series Software
Configuration Guide and continue with Step 9.
Step 9
Connect to the serial port.