Panasonic NV-DS65EG Manuel D’Utilisation

COPY INHIBITED:

Because the medium is protected 
by a copy guard, images cannot be 
recorded correctly.

CAN NOT CHANGE MODE:

The Mode of the Movie Camera can 
not be changed in the PC 
connection Mode.

DISCONNECT DV CABLE:

If the Movie Camera is in Photo 
Title (CAMERA mode) and the DV 
Interface Cable is connected, 
“DISCONNECT DV CABLE” 
appears. In this case, remove the 
DV Interface Cable from the Movie 
Camera.

DISCONNECT USB CABLE:

If you are attempting to record from 
a Cassette by pressing the PHOTO 
SHOT Button when the USB Cable 
is connected, “DISCONNECT USB 
CABLE” appears. In this case, 
remove the USB Cable from the 
Movie Camera.

PICTURE (Blink during 3 seconds):

When making DV connection at the 
time of M-CARD mode.

WEBCAM (Blink during 3 seconds):

When making DV connection at the 
time of Web Camera mode.

STORAGE (Blink during 3 seconds):

When making DV connection at the 
time of USB Device Drive/SD Drive.

ª Selecting Remote Controller 

When 2 Movie Cameras are used simultaneously, 
they can be operated individually by selecting 
different Remote Controller Modes.
≥If the Remote Controller Mode of the Movie 

Camera and that of the Remote Controller do not 
match, [REMOTE] Indication is displayed.

Setup on the Movie Camera:
Set [REMOTE] on the [OTHER FUNCTIONS] 
Sub-Menu to the desired Remote Controller 
Mode. (

l 14)

Setup on the Remote Controller:
[VCR1]: Press the [

D] Button and [∫] Button 

simultaneously.

[VCR2]: Press the [

E] Button and [∫] Button 

simultaneously.

≥When the battery in the Remote Controller is 

replaced, the mode is automatically reset to 
[VCR1] Mode.

ª Concerning the Power Supply

≥When the Movie Camera is used for a long time, 

the Camera body becomes warm, but this is not 
a malfunction.

≥If the [CHARGE] Lamp does not light up 

although the Battery is attached to AC Adaptor, 
detach the Battery and reattach it.

≥Battery CGP-D110 and CGP-D105 cannot be 

charged with this AC Adaptor.

ª Inserting/Removing the Cassette

≥If a new Cassette is inserted, rewind to the 

beginning of the tape before starting recording.

≥When inserting the cassette, make sure it faces 

in the right direction and then push it in until it 
stops.

ª Alarm Sounds

When [BEEP SOUND] on the [OTHER 
FUNCTIONS] Sub-Menu on the [CAMERA 
FUNCTIONS] Main-Menu is set to [ON], 
confirmation/alarm beeps are issued as follows.
1 Beep
≥When you start recording.
≥When you switch the [VCR/OFF/CAMERA/

M-CARD] Switch from [OFF] to Camera Mode or 
Card Recording Mode.

2 Beeps
≥When you pause recording.
4 Beeps
≥If you perform a wrong operation before or 

during recording.

ª Recording

≥Before turning on the power, remove the Lens 

Cap. If the Lens Cap is still attached when the 
power is turned on, Automatic White Balance 
Adjustment (

l 56) may not function correctly.

ª Recording Check

≥For Recording Check, the recording speed mode 

(SP/LP) must be the same as the mode used for 
the recording. If different, playback images will 
be distorted.

ª Recording with the Built-in Video 

≥The subject should be within 1.5 metres of the 

Movie Camera.

≥Using the Video Light reduces battery time.
≥Set the Video Light to off when not in use.
≥Do not look directly into the light.
≥If the Video Light is used with a Conversion lens 

attached, a slight vignetting (darkening around 
edges) effect occurs on the screen.

EG-ENG.book  46 ページ  ２００３年１月６日　月曜日　午後３時４３分