Panasonic PV-GS19 Manuel D’Utilisation

Before Using

[VCR1]:

Press the [

ǿŹ] Button and [ Ŷ ] Button

simultaneously.

[VCR2]:

Press the [

Żǿ] Button and [ Ŷ ] Button

simultaneously.

• When the battery in the Remote Control is replaced,

the mode is automatically reset to [VCR1] Mode.

Setup on the Camcorder

Set [ REMOTE] on the [ SETUP] Sub-Menu to
the desired Remote Control Mode. (pp. 22, 23)

Setup on the Remote Control

Power Supply

Using the AC Adaptor

Connect the DC Cable to the Camcorder.

Connect the DC Cable to the AC Adaptor.

Connect the AC Cable to the AC Adaptor

and the AC Jack.

• Before connecting or disconnecting the

power supply, set the [OFF/ON] Switch

the Camcorder to [OFF] and make sure that
[POWER] Lamp

is not lit. (p. 18)

Using the Battery

• We recommend using a Panasonic Battery.
• We cannot guarantee the quality of this Camcorder

when batteries from other companies are used.

Attach the Battery to the AC Adaptor and

charge it.

Put the Battery on the Battery Mount by

aligning the mark, and then securely plug it
in.

Before use, fully charge the Battery.

• Since the Battery will not be charged when

the DC Cable is connected to the AC Adaptor,
disconnect it from the AC Adaptor.

• The [CHARGE] Lamp lights up, and charging

starts.

• When the [CHARGE] Lamp goes off, charging is

completed.

• When the battery is completely discharged, the

[CHARGE] Lamp blinks at first, but the battery is
charged normally. When the temperature of the
battery is too high or low, the [CHARGE] Lamp
blinks and the charging time becomes longer
than usual.

Attach the charged Battery to the

Camcorder.

• For other notes concerning this item, see page 59.

Disconnecting the Power Source

Set the [OFF/ON] Switch

to [OFF], and while

sliding the [BATTERY RELEASE] Switch

remove the Battery downward or DC Cable.
• When attaching or removing Battery, set the

[OFF/ON] Switch to [OFF] and make sure the
[POWER] Lamp is not lit.

• Hold down the battery with your hand so it does

not fall.