AT&T 3 Manuel D’Utilisation
Before You Begin
Preparing the Communications System
You must program a few communications system features before you program
the mail system. The following instructions assume that you are familiar with
the mail system. The following instructions assume that you are familiar with
communications system programming. If you are not, refer to the Programming
and Use guide for the communications system.
and Use guide for the communications system.
For these procedures, you need communications system Planning Forms B1
and B2 to identify the extension numbers associated with the mail system unit
and the Remote Maintenance Device.
and B2 to identify the extension numbers associated with the mail system unit
and the Remote Maintenance Device.
Hunt Group Extensions
Use this procedure to assign the extensions associated with the mail system
unit to Hunt Group 7, the VMS Hunt Group.
unit to Hunt Group 7, the VMS Hunt Group.
1.
2.
3.
4.
5.
6.
7.
8.
9.
At extension 10 or 11, press [
Feature
] [
0
] [
0
] [
System Program
] [
System Program
].
Press [
#
] [
5
] [
0
] [
5
].
At the
Group:
prompt, press [
7
].
At the
Extension:
prompt, enter the first PARTNER MAIL extension
NOTE:
The first extension jack on 206 modules should not be used as a
PARTNER MAIL extension. These jacks should be reserved for use
during a power failure.
during a power failure.
Press [
Next Data
] until the display reads
1 Assigned.
Press [
Next Item
] or [
Prev Item
] until the next PARTNER MAIL extension number
displays.
Press [
Next Data
] until the display reads
1 Assigned.
If additional PARTNER MAIL extensions are specified on Form B1, repeat
Steps 6 and 7 for each one.
Steps 6 and 7 for each one.
3-2
Mail System Initial Programming